![]() 54mm is borderline I need that thick or thicker less and the part falls apart) I just took my calipers to the parts and that explains everything but not a solution. Here is a video on youtube clearly showing what I am talking about. ![]() 95 (stock the way simplify set it) in this file its 1.15 (I am trying to up it to see if that gets me thicker walls on the parts that print too thin) I will know in 30 minutes or so. What is changing and how do I stop it? I want it all "thick" like the bottom section.Īttached is the factory file. There is a HUGE thickness difference in the walls of the bottom piece and the middle and top piece. but the middle is so weak its hard to even get it out of the printer without it coming apart in my fingers. I change NOTHING in settings and since I am printing spiral vase mode it should not matter what portion of the model I am printing all walls should be the same since no settings are changing. the top prints "ok" the middle is so brittle and thin its unusable. I enlarge the rocket 3 times my print bed height. I had to seperate and resolid it in 3d to get it proper but thats fine got a good outline tool path now for single outline mode. I have a rocket I am printing off thingiverse. not only is it much faster but its actually usable. I like printing my rockets in spiral vase mode.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |